RussianEstonianEnglish
6 571 567
Best sellers
SMD lamp 3W2700K15h200lmGU10 200 lm, 3 W, 2700 K, 220-240 V, 15000 h,
2.00 EUR
2.5", SATA 3.0, TLC, Write speed: 320 MB/s, Read speed: 500 MB/s, Drive thickness 7mm, MTBF 1000000...
31.80 EUR
32.12
Lithium Button celles 3V 1-pack
0.45 EUR
2.5", SATA/600, 5400RPM, 8MB cache
82.00 EUR
1.30 EUR
3.00 EUR
SATA 3.0, Technology TLC, Write speed 510 MBytes/sec, Read speed 560 MBytes/sec, Form Factor 2,5", D...
117.00 EUR
118.90
5.80 EUR

soDIMM memory install

 

STEP 1

Disconnect the AC power cord and remove the battery.


 

STEP 2

Prior to handling the memory module(s), always touch an unpainted and grounded metal object or use a grounded antistatic wrist strap to prevent electrostatic discharge (ESD).


 

STEP 3

If necessary, remove pre-existing memory by gently pulling the lock/ejector tabs (located on both sides of the memory socket) away from the memory module. The memory will unlock and pop-up 30 degrees for removal.

Note: Never apply pressure or handle the memory module on or around the Integrated Circuits (IC)! Always handle the memory at the upper-most corners of the Printed Circuit Board (PCB).


 

STEP 4

Align the memory module key along with the memory socket key and insert the memory at a 30 degree angle.


 

STEP 5

Rotate the memory downward until the lock/ejector tabs engage and click into place.


 

STEP 6

Replace the battery and plug in the AC power cord.